![]() ![]() ![]() Once Key Light is added to your network, you can control it via any Mac or Windows PC within your network.Ĥ) Launch Control Center and pair Key Light by clicking the + icon.ĥ) Use Control Center to switch on/off, adjust brightness, and fine-tune color temperature. Wi-Fi connection is only needed for initial pairing. It will take approximately 15 seconds to boot up.ģ) If your PC is not equipped with Wi-Fi, use the Elgato Control Center app from the App Store to add and control Key Light from an iOS or Android device. These are the steps you take to use Control Center with your Key Light.ġ) Download and install the Control Center app.Ģ) Switch on your Key Light. Visit the Downloads page, and select Control Center.įor information on how to pair your Key Light to your Mac, see this article:įor information on how to pair your Key Light to your PC, see this article:įor information on how to pair your Key Light to your Android device, see this article:įor information on how to pair your Key Light to your iOS device, see this article: Key Light is controlled using the Control Center software for macOS, iOS or Windows. After that, it will be connected to your network, even after you turn it off and on again many times. Key Light can be paired to a 2.4 Ghz Wi-Fi network using a macOS, Windows, Android or iOS device that features a Wi-Fi connection. Connect the power supply and plug it into a power outlet.Tighten the clamp to your desk, but do not overtighten.Push the button to engage the ratchet when tightening.However, you shouldn't have to use too much force. When loosening a grip on the pole, it might take a small amount of effort to start the process.It is normal for the pole to shake when fully extended.It is recommended that you remove it when mounting Key Light. A non-slip rubber washer is included for mounting a camera, camcorder, etc.Extend the pole to your preferred height. Screw Key Light directly onto the pole via the integrated socket and screw.You can choose the one that best meets your needs. The Key Light panel has 4 mounting screw holes - one on each edge.It comes with a detailed Quick Start Guide in the box, but here is some additional information for you. ![]() Key Light is a device that requires both hardware and software setup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |